Filter
Top Products
VPN > DHCP over VPN
922
SonicOS 5.8.1 Administrator Guide
Devices
9. To configure devices on your LAN, click the Devices tab.
10. To configure Static Devices on the LAN, click Add to display the Add LAN Device Entry
window, and type the IP address of the device in the IP Address field and then type the
Ethernet address of the device in the Ethernet Address field.
An example of a static device is a printer as it cannot obtain an IP lease dynamically. If you
do not have Block traffic through tunnel when IP spoof detected enabled, it is not
necessary to type the Ethernet address of a device. You must exclude the Static IP
addresses from the pool of available IP addresses on the DHCP server so that the DHCP
server does not assign these addresses to DHCP clients. You should also exclude the IP
address used as the Relay IP Address. It is recommended to reserve a block of IP address
to use as Relay IP addresses. Click OK.
11. To exclude devices on your LAN, click Add to display the Add Excluded LAN Entry
window. Enter the MAC address of the device in the Ethernet Address field. Click OK.
12. Click OK to exit the DHCP over VPN Configuration window.
Note You must configure the local DHCP server on the remote SonicWALL security appliance to
assign IP leases to these computers.
Note If a remote site has trouble connecting to a central gateway and obtaining a lease, verify that
Deterministic Network Enhancer (DNE) is not enabled on the remote computer.