Filter
Top Products
Configuring WAN Acceleration
1315
SonicOS 5.8.1 Administrator Guide
Configuring TCP Acceleration
The TCP Acceleration service can be deployed in three different deployment scenarios
including: site-to-site VPN, routed mode, and layer 2 bridge mode. This section explains how
to configure these deployment scenarios in the following subsections:
• Configuring TCP Acceleration on a Site-to-Site VPN, page 1315
• Configuring TCP Acceleration on a Non-VPN (Routed Mode), page 1317
• Configuring the TCP Acceleration Tab, page 1323
Configuring TCP Acceleration on a Site-to-Site VPN
To configure the TCP Acceleration service using a site-to-site Virtual Private Network (VPN),
follow the steps listed below:
Note If you have a site to site VPN, you can use a spare SonicWALL NSA/TZ series appliance in
Layer 2 bridge mode with a SonicWALL WXA series appliance connected. Refer to the
SonicOS Administrators Guide for Layer 2 bridge mode configuration.
Step 1 Navigate to the VPN > Settings page.
Figure 37 VPN > Settings
Step 2 Click the Configure button for the VPN policy you wish to use.