Filter
Top Products
Firewall Settings > BWM
722
SonicOS 5.8.1 Administrator Guide
Step 4 Click the Configure icon in the Configure column for the interface for which you want to set
BWM.
The Edit
Interface dialog is displayed.
Note If using Bandwidth Management Type WAN, you can only enable BWM on a WAN interface.
If using Type: None, you cannot set the Ingress or Egress bandwidth.
Step 5 Click the Advanced tab.
Step 6 Under Bandwidth Management, check Enable Egress or Enable Ingress or both checkboxes,
and then enter the available bandwidth in kilobits per second (Kbps).
Step 7 Click OK.
Configuring Firewall Access Rules
You can configure BWM for each firewall rule. This method configures the direction in which to
apply BWM and sets the priority queue.
To configure BWM for a firewall rule, perform the following steps: