Filter
Top Products
1397
SonicOS 5.8.1 Administrator Guide
CHAPTER 87
Chapter 87: Configuring Internet Connectivity on
SonicWALL Appliances
Wizards > Setup Wizard
The first time you log into your SonicWALL appliance, the Setup Wizard is launched
automatically. To launch the Setup Wizard at any time from the management interface, click
the Wizards button in the top right corner, and select Setup Wizard.
Tip You can also configure all your WAN and network settings on the Network > Settings page
of the SonicWALL Management Interface
Using the Setup Wizard
The Setup Wizard helps you configure the following settings:
• WAN networking mode and WAN network configuration
• 3G or Analog Modem configuration (SonicWALL TZ series)
• LAN network configuration
• Wireless LAN network configuration (wireless devices)
Configuring a Static IP Address with NAT Enabled
Using NAT to set up your SonicWALL eliminates the need for public IP addresses for all
computers on your LAN. It is a way to conserve IP addresses available from the pool of IPv4
addresses for the Internet. NAT also allows you to conceal the addressing scheme of your
network. If you do not have enough individual IP addresses for all computers on your network,
you can use NAT for your network configuration.