SonicWALL 5.8.1 Microscope & Magnifier User Manual


  Open as PDF
of 1490
 
Network > Services
319
SonicOS 5.8.1 Administrator Guide
ESP (50)—(Encapsulated Security Payload) A method of encapsulating an IP datagram
inside of another datagram employed as a flexible method of data transportation by IPsec.
AH (51)—(Authentication Header) A security protocol that provides data authentication and
optional anti-relay services. AH is embedded in the data to be protected (a full IP
datagram).
EIGRP (88)—(Enhanced Interior Gateway Routing Protocol) Advanced version of IGRP.
Provides superior convergence properties and operating efficiency, and combines the
advantages of link state protocols with those of distance vector protocols.
OSPF (89)—(Open Shortest Path First) A routing protocol that determines the best path for
routing IP traffic over a TCP/IP network based on distance between nodes and several
quality parameters. OSPF is an interior gateway protocol (IGP), which is designed to work
within an autonomous system. It is also a link state protocol that provides less router to
router update traffic than the RIP protocol (distance vector protocol) that it was designed to
replace.
PIMSM (103)—(Protocol Independent Multicast Sparse Mode) One of two PIM operational
modes (dense and sparse). PIM sparse mode tries to constrain data distribution so that a
minimal number of routers in the network receive it. Packets are sent only if they are
explicitly requested at the RP (rendezvous point). In sparse mode, receivers are widely
distributed, and the assumption is that downstream networks will not necessarily use the
datagrams that are sent to them. The cost of using sparse mode is its reliance on the
periodic refreshing of explicit join messages and its need for RPs.
L2TP (115)—(Layer 2 Tunneling Protocol) A protocol that allows a PPP session to run over
the Internet. L2TP does not include encryption, but defaults to using IPsec in order to
provide virtual private network (VPN) connections from remote users to the corporate LAN.
Adding Custom Services for Predefined Service Types
You can add a custom service for any of the predefined service types:
Protocol IP Number
ICMP 1
TCP 6
UDP 17
GRE 47
IPsec ESP 50
IPsec AH 51
IGMP 2
EIGRP 88
OSPF 89
PIM SM 103
L2TP 115