Filter
Top Products
Network > Interfaces
229
SonicOS 5.8.1 Administrator Guide
If you are using PPPoE, a Client Settings section displays in the Protocol tab:
Step 3 If you want PPPoE to disconnect after a specific time period, Click the Inactivity Disconnect
checkbox and enter the time period (in minutes).
Step 4 If you want to use LCP echo packets for server keep-alive, click the Strictly use LCP echo
packets for server keep-alive checkbox.
Step 5 If you want the PPPoE client to reconnect to the server when traffic is not sent for a specific
time period, enter the time period (in minutes) in the text field. This checkbox is selected by
default.
Step 6 Click the OK button
Configuring the NSA Expansion Pack Module Interface (NSA 2400MX and 250M only)
The SonicWALL NSA 2400MX and NSA 250M security appliances support the following
optional NSA Expansion Pack modules:
• 1-Port ADSL (RJ-11) Annex A module
• 1-Port ADSL (RJ-45) Annex B module
• 1-Port T1/E1 module
• 2-Port LAN Bypass module
• 2-Port SFP module
• 4-Port Gigabit Ethernet module (SonicWALL NSA 2400MX)
• 4-Port Gigabit Ethernet module (SonicWALL NSA 250M series)
These interfaces are listed in the Interface Settings table as the Mx interfaces.
Caution Before attempting to insert and configure the module, you must power off the appliance.
Once the appliance has been powered down, remove the rear module plate cover and insert
the expansion module.Tighten the screws to secure the module, then power on the
appliance.
Log into the SonicWALL management interface. You can now begin configuring the desired
expansion module. The following sections describe how to configure the
• “Configuring the ADSL Expansion Module” on page 230
• “Configuring the T1/E1 Module” on page 233
• “Configuring the LAN Bypass Module” on page 236
• “Configuring the 2 Port SFP or 4 Port Gigabit Ethernet Modules (NSA 2400MX and NSA
250M)” on page 237