Filter
Top Products
Appendix A: CLI Guide
1456
SonicOS Enhanced 5.6 Administrator’s Guide
radio-a wpa interval
<uvalue>
Sets the length of time between
re-keying the WPA key
radio-a wpa psk <string> Sets WiFi Protected Access
Pre-shared key passphrase
[no] radio-g enable Enables or disables 802.11g radio
band wireless connections
[no] radio-g acl enable Enables or disables the Access Control
List
radio-g acl allow
<string>
Adds a specific MAC address to the
Access Control List (ACL) to allow
802.11g radio band wireless
connections to a SonicPoint
radio-g acl deny <string> Adds a specific MAC address to the
denied Access Control List, preventing
802.11g radio band wireless
connections to a SonicPoint
radio-g acl mode
<deny|allow|
disabled|enabled>
Sets Access Control List enforcement
radio-g acl object-handle
<string>
Sets 802.11g radio ACL to allow list
object handle
radio-g antenna-diversity
<one|two|both>
Sets which antenna the SonicPoint
uses to send and receive data
radio-g authtype
<both|open|psk|shared>
Sets the method type for authentication
radio-g beacon-interval
<uvalue>
Sets the interval (in milliseconds)
between broadcasts of the wireless
beacon
radio-g channel <uvalue> Sets the channel the radio will operate
on
radio-g datarate
<b1|b11|b2|b5|best|g1|g1
1
|g12|g18|g2|g24|g36|g48|
g5|g54|g6|g9|super108|
super12|super18|super24|
super36|super48|super72|
super96>
Sets the data rate at which data is
transmitted and received
radio-g dtim <uvalue> Sets 802.11g radio DTIM, which is the
numbers of beacon frames that must
occur before the radio sends buffered
multicast frames
radio-g frag-thresh
<uvalue>
Sets the number of bytes of frag-
mented data for the SonicPoint to allow
[no] radio-g g-only Allows only 802.11g clients to connect
[no] radio-g hide-ssid Sets SSID to be broadcast as part of
the wireless beacon, rather than as a
separate broadcast
radio-g maxclients
<uvalue>
Sets maximum number of clients that
can the SonicPoint can support at one
time
Command Description