Filter
Top Products
Network > Interfaces
253
SonicOS 5.8.1 Administrator Guide
Configuring Wireless Zone Settings
In the case where you are using a HP PCM+/NIM system, if it will be managing a HP ProCurve
switch on an interface assigned to a WLAN/Wireless zone, you will need to deactivate two
features, otherwise you will not be able to manage the switch. Go to the Network > Zones page
and select your Wireless zone. On the Wireless tab, clear the checkboxes next to Only allow
traffic generated by a SonicPoint and WiFiSec Enforcement. Click OK to save and activate
the change.
Configuring Layer 2 Bridge Mode Procedure
Refer to the “L2 Bridge Interface Zone Selection” section on page 201 for choosing a topology
that best suits your network. In this example, we will be using a topology that most closely
resembles the Simple L2 Bridge Topology.
Choose an interface to act as the Primary Bridge Interface. Refer to the “L2 Bridge Interface
Zone Selection” section on page 201 for information in making this selection. In this example,
we will use X1 (automatically assigned to the Primary WAN):