Filter
Top Products
983
Input/Output
the Trig 1 Out or Trig 2 Out represents the time the gate is configured to pass the signal.
Odd/Even Trace Point
Selects either the odd or even trace points as the signal to be output to the Trig 1 Out or Trig 2 Out
connector when performing swept spectrum analysis. When the polarity is positive, this output goes high
during the time the test set is sweeping past the first point (Point 0) and every other following trace point.
The opposite is true if the polarity is negative.
Source Point Trigger
Selects the gate signal to be output to the Trig 1 Out or Trig 2 Out connector for use as the Point Trigger
when operating an external source in Tracking mode. When Ext Trigger 1 is selected as the Point
Trigger under Source, the Source Point Trigger under Trig1 Out automatically gets selected. Similarly,
when Ext Trigger 2 is selected as the Point Trigger under Source, the Source Point Trigger key under
Trig2 Out automatically gets selected
Source Marker 1
This key is only available in the EXT.
Trigger output at marker 1 in current playing Waveform file.
Key Path: Input/Output, Output Config, Trig 1/2 Output
Example: TRIG1:OUTP GATE
Readback: Gate
Initial S/W Revision: Prior to A.02.00
Key Path:
Input/Output, Output Config, Trig 1/2 Output
Example: TRIG1:OUTP OEV
Readback: Odd/Even
Initial S/W Revision: Prior to A.02.00
Key Path:
Input/Output, Output Config, Trig 1/2 Output
Example: TRIG1:OUTP SPO
Readback: Source Point
Initial S/W Revision: Prior to A.02.00
Key Path:
Input/Output, Output Config, Trig 1/2 Output
Example: :TRIG1:OUTP S1M
ReadBack: Marker 1
Initial S/W Revision: A.05.01