Filter
Top Products
11 30
Save
• 210.000000,17.00
• 225.000000,14.80
The choices for the 1 of N fields in the metadata are as follows:
• Frequency Unit: Hz, kHz, MHz, GHz
• Antenna Unit: dBuv/m, dBuA/m, dBG, dBpT, None
• Frequency Interpolation: Logarithmic, Linear
Multiport Adapter Amplitude Correction
Pressing this key selects Multiport Adapter Amplitude Corrections as the data type to be exported.
Pressing this key again brings up the Select Menu, which allows the user to select which Multiport
Adapter Amplitude Correction to save.
Amplitude Corrections are fully discussed in the documentation of the Input/Output key, under the
Corrections softkey.
Key Path:
Save, Data, Amplitude Correction
Remote Command: :MMEMory:STORe:MPADapter:CORRection
1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16, <filename>
Example: :MMEM:STOR:MPAD:CORR 2 "myAmpcor.csv" saves Multiport Adapter
Correction 2 to the file myAmpcor.csv on the current path.
The default path is My Documents\amplitudeCorrections.
Notes: If the save is initiated via SCPI, and the file already exists, the file will be
overwritten.
Using the C: drive is strongly discouraged, since it runs the risk of being
overwritten during an instrument software upgrade.
Both single and double quotes are supported for any filename parameter over
SCPI.
Dependencies: Corrections are not supported by all Measurements. If in a Mode in which
some Measurements support it, this key will be grayed out in measurements
that do not. The key will not show at all if no measurements in the Mode
support it.
This key will not appear unless you have the proper option installed in your
instrument.
Readback: Selected Correction
Backwards Compatibility SCPI: For backwards compatibility only, the following parameters syntax is
supported:
:MMEMory:STORe:MPADapter:CORRection
ANTenna|CABLe|OTHer|USER, <filename>
ANTenna maps to 1, CABle maps to 2, OTHer maps to 3 and USER maps to 4
Initial S/W Revision: A.10.00