Filter
Top Products
274
System Functions
System
Date
Enables you to configure the date of the scheduled task. The SCPI command to configure the date and time
parameters of the scheduler is the same; however, they each have their own front-panel control.
Time
Enables you to configure the time of the scheduled task. The SCPI command to configure the date and time
parameters of the scheduler is the same; however, they each have their own front panel-control.
Recurrence
Enables you to configure the scheduler to run the task recurrently on a scheduled date and time. You can schedule
it to run daily, weekly or alternate weeks.
Key Path:
System, Alignments, RF Preselector, Schedule Setup, Date/Time
Notes:
See“Date/Time ” on page 273.
For model N9038A only.
Preset: This is unaffected by Preset but is set to Current date and 00:00:00 on a
“Restore System Defaults->Align”.
State Saved: No
Initial S/W Revision: A.08.00
Key Path:
System, Alignments, RF Preselector, Schedule Setup, Date/Time
Notes: See “Date/Time ” on page 273 .
For model N9038A only.
Preset: This is unaffected by Preset but is set to Current date and 00:00:00 on a
“Restore System Defaults->Align”.
State Saved: No
Initial S/W Revision: A.08.00
Key Path:
System, Alignments, RF Preselector, Schedule Setup
Mode: All
Remote Command: :CALibration:RFPSelector:SCHeduler:RECurrence
DAY|WEEK|OFF
:CALibration:RFPSelector:SCHeduler:RECurrence?
Example: :CAL:RFPS:SCH:REC DAY
Notes: For model N9038A only.
Preset: This is unaffected by Preset but is set to OFF on a “Restore System
Defaults->Align”.
State Saved: No