Filter
Top Products
942
Input/Output
low end point is will be extended down to 0 Hz. So for a Corrections array to have no effect outside its
range, you should start and end the array at 0 dB.
NOTE The table editor will only operate properly if the test set is sweeping, because its
updates are tied to the sweep system. Thus, you should not try to use the editor in
single sweep, and it will be sluggish during compute-intensive operations like
narrow-span FFT sweeps.
When exiting the edit menu (by using the
Return key or by pressing an instrument front-panel key), the
editor window turns off and the Ampcor trace is no longer displayed; however,
Apply Corrections
remains
On, any correction that was on while in the editor remains on, and the amplitude scale returns to
its previous setting.
Corrections arrays are not affected by a Preset, because they are in the Input/Output system. They also
survive shutdown and restarting of the test set application, which means they will survive a power cycle.
Navigate
Lets you move through the table to edit the desired point.
Frequency
Lets you edit the frequency of the current row.
Amplitude
Lets you edit the Amplitude of the current row.
Key Path: Input/Output, Corrections
Initial S/W Revision: A.02.00
Key Path:
Input/Output, Corrections, Edit
Notes: There is no value readback on the key
Min: 1
Max: 2000
Initial S/W Revision: A.02.00
Key Path:
Input/Output, Corrections, Edit
Notes: There is no value readback on the key.
Min: 0
Max: 1 THz
Initial S/W Revision: A.02.00
Key Path:
Input/Output, Corrections, Edit