Filter
Top Products
1397
View/Display
Title
Displays menu keys that enable you to change or clear a title on your display.
Change Title
Writes a title into the "measurement name" field in the banner, for example, "Channel Power".
Press
Change Title to enter a new title through the alpha editor. Press Enter or Return to complete the
entry. Press
Cancel (Esc) to cancel the entry and preserve your existing title.
The display title will replace the measurement name. It remains for this measurement until you press
Change Title again, or you recall a state, or a Preset is performed. A title can also be cleared by pressing
Title, Clear Title.
NOTE Notice the inclusion of the <measurement> parameter in the command below.
Because each measurement remembers the Display Title, the command must be
qualified with the measurement name.
Clear Title
Clears a title from the front-panel display. Once cleared, the title cannot be retrieved. After the title is
cleared, the current Measurement Name replaces it in the title bar.
Key Path: View/Display, Display
Initial S/W Revision: Prior to A.02.00
Key Path:
View/Display, Display, Title
Mode: All
Remote Command: :DISPlay:<measurement>:ANNotation:TITLe:DATA <string>
:DISPlay:<measurement>:ANNotation:TITLe:DATA?
Example: DISP:ACP:ANN:TITL:DATA "This Is My Title"
This example sets the title to: This Is My Title
Notes: Pressing this key cancels any active function.
When a title is edited the previous title remains intact (it is not cleared) and the
cursor goes at the end so that characters can be added or BKSP can be used to
go back over previous characters.
Preset: No title (measurement name instead)
State Saved: Saved in instrument state.
Initial S/W Revision: Prior to A.02.00
Modified at S/W Revision: A.02.00, A.03.00
Key Path:
View/Display, Display, Title