Filter
Top Products
213
System Functions
Save
My Documents\Sequences
Data (Export)
Exporting a data file stores data from the current measurement to mass storage files. The Export Menu
only contains data types that are supported by the current measurement.
Since the commonly exported data files are in .csv format, the data can be edited by you prior to
importing. This allows youto export a data file, manipulate the data in Excel (the most common PC
Application for manipulating .csv files) and then import it.
Selecting an Export Data menu key will not actually cause the exporting to occur, since the analyzer still
needs to know where you wish to save the data. Pressing the Save As key in this menu brings up the Save
As dialog and Save As menu that allows you to specify the destination file and directory. Once a
filename has been selected or entered in the Open menu, the export will occur as soon as the Save key is
pressed.
Save As . . .
When you press “Save As”, the analyzer brings up a Windows dialog and a menu entitled “Save As.”
This menu allows you to navigate to the various fields in the Windows dialog without using a keyboard
or mouse. The
Tab and Arrow keys can also be used for dialog navigation.
See“To File . . .” on page 205in
Save, State for a full description of this dialog and menu.
The default path for saving files is:
Key Path: Save, Sequences
Mode: All
Notes: Brings up Save As dialog for saving a Sequence Save Type
Initial S/W Revision: A.05.00
Key Path:
Save
Mode: All
Notes: The menu is built from whatever data types are available for the mode. So the
key locations in the sub menu will vary.
No SCPI command directly controls the Data Type that this key controls. The
Data Type is included in the MMEM:STORe commands.
Dependencies: If a file type is not used by a certain measurement, that type is grayed out for
that measurement. The key for a file type will not show at all if there are no
measurements in the Mode that support it.
Preset: Is not affected by a Preset or shutdown, but is reset during Restore Mode
Defaults
Readback: The data type that is currently selected
Initial S/W Revision: Prior to A.02.00