Filter
Top Products
867
AMPTD Y Scale
0.25 V Peak
Set the channel gain state to 0.25 Volt Peak.
0.125 V Peak
Set the channel gain state to 0.125 Volt Peak.
Scale / Div
Sets the units per vertical graticule division on the display. This function is only available when Scale
Type (Log) is selected and the vertical scale is power. When Scale Type (Lin) is selected, Scale/Div is
grayed out.
Scale Type
Chooses a linear or logarithmic vertical scale for the display and for remote data readout.
When Scale Type (Log) is selected, the vertical graticule divisions are scaled in logarithmic units. The
top line of the graticule is the Reference Level and uses the scaling per division Scale/Div to assign
values to the other locations on the graticule.
When Scale Type (Lin) is selected, the vertical graticule divisions are linearly scaled with the reference
level value at the top of the display and zero volts at the bottom. Each vertical division of the graticule
represents one-tenth of the Reference Level.
Key Path: AMPTD Y Scale, I Range | Q Range
Initial S/W Revision: Prior to A.02.00
Key Path:
AMPTD Y Scale, I Range | Q Range
Initial S/W Revision: Prior to A.02.00
Key Path:
AMPTD Y Scale
Remote Command: :DISPlay:WINDow[1]:TRACe:Y[:SCALe]:PDIVision <rel_ampl>
:DISPlay:WINDow[1]:TRACe:Y[:SCALe]:PDIVision?
Example: DISP:WIND:TRAC:Y:PDIV 5 DB
Dependencies: Scale/Div is grayed out in linear Y scale. Sending the equivalent SCPI
command does change the Scale/Div, though it has no affect while in Lin.
Preset: 10.00 dB / Div
State Saved: Saved in instrument state
Min: 0.10 dB
Max: 20 dB
Initial S/W Revision: Prior to A.02.00