Filter
Top Products
1401
View/Display
On
Turns the display backlight on.
Off
Turns the display backlight off.
Backlight Intensity
An active function used to set the backlight intensity. It goes from 0 to 100 where 100 is full on and 0 is
off. This value is independent of the values set under the Backlight on/off key.
Full Screen
When Full Screen is pressed the measurement window expands horizontally over the entire instrument
display. The screen graticule area expands to fill the available display area.
It turns off the display of the softkey labels, however the menus and active functions still work. (Though
it would obviously be very hard to navigate without the key labels displayed.) Pressing
Full Screen
again while Full Screen is in effect cancels Full Screen.
Note that the banner and status lines are unaffected. You can get even more screen area for your data
display by turning off the Meas Bar (in the Display menu) which also turns off the settings panel.
Key Path: View/Display, Display, System Display Settings, Backlight
Example: DISP:BACK ON
Readback: On
Initial S/W Revision: Prior to A.02.00
Key Path:
View/Display, Display, System Display Settings, Backlight
Example: DISP:BACK OFF
Readback: Off
Initial S/W Revision: Prior to A.02.00
Key Path:
View/Display, Display, System Display Settings
Remote Command: :DISPlay:BACKlight:INTensity <integer>
:DISPlay:BACKlight:INTensity?
Example: DISP:BACK:INT 50
Preset: 100 (Set by Restore Misc Defaults)
Min: 0
Max: 100
Initial S/W Revision: Prior to A.02.00