Filter
Top Products
959
Input/Output
Select Correction
Specifies the selected correction. The term "selected correction" is used throughout this document to specify which
correction will be affected by the functions.
Correction On/Off
Turning the Selected Correction on allows the values in it to be applied to the data. This also automatically turns on
"Apply Corrections" (sets it to ON), otherwise the correction would not take effect.
A new sweep is initiated if an amplitude correction is switched on or off. Note that changing, sending or loading
corrections data does NOT directly initiate a sweep, however in general these operations will turn corrections on,
which DOES initiate a sweep.
Key Path:
Input/Output, RF Output & Test Set Config, Multiport adapter, Corrections
Mode: Sequence Analyzer, I/Q Analyzer
Notes: The selected correction is remembered even when not in the correction menu
Dependencies: This menu selection does not have any effect unless Input/Output, More, RF
Output & Test Set Config, Multiport Adapter, Multiport Adapter is set to the
On state.
Preset: Set to Correction 1 by Restore Input/Output Defaults
Readback: Correction 1|Correction 2|Correction 3|Correction 4|Correction 5|Correction
6|Correction 7| Correction 9|Correction 9|Correction 10|Correction
11|Correction 12
Initial S/W Revision: A.10.00
Key Path:
Input/Output, RF Output & Test Set Config, Multiport Adapter,
Corrections
Remote Command: [:SENSe]:MPADapter:CORRection:CSET[1]|2|3|4|5|6|7|8|9|1
0|11|12|13|14|15|16[:STATe] ON|OFF|1|0
[:SENSe]:MPADapter:CORRection:CSET[1]|2|3|4|5|6|7|8|9|1
0|11|12|13|14|15|16[:STATe]?
Example: SENS:MPAD:CORR:CSET ON