Filter
Top Products
1246
Source (Internal)
Time
Sets the duration of the current step to be a time value for the length of time the step will play. Pressing this key
again opens another menu which allows you to set the time value for the step duration.
Duration Time
Allows you to specify the length of time the current step will play.
If the Transition Time value is longer than the Step Duration Time, an error is generated when initiating a source
list sequence. For source list sequence, transition time is included in the step duration length. If the Transition Time
value is longer than the Step Duration Time, the real step duration length is extended to equal the transition time
and cause a timing shift.
Play Count
Sets the duration of the current step to be an integer value for the number of times (play count) the ARB file is
Key Path:
Source, List Sequencer, List Sequencer Setup, Step Duration
Example: SOUR:LIST:STEP2:SET:DUR:TYPE TIME
Notes: SCPI is supported after A.09.40
Initial S/W Revision: A.05.00
Key Path:
Source, List Sequencer, List Sequencer Setup, Step Duration, Time
Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:DURation:TCOunt
<double>
:SOURce:LIST:STEP[1]|2|3…1000:SETup:DURation:TCOunt?
Example: SOUR:LIST:STEP2:SET:DUR:TCO 1s
SOUR:LIST:STEP2:SET:DUR:TCO?
Notes: SCPI is supported after A.09.40
This SCPI is reused by “Play Count” and “Duration Time” according to
current Duration Type setting if “Play Count” or “Duraton Time”.
If current “Duration Type” is “Continuous”, then popup error –221,"Settings
conflict;Cannot accept time or count input when step duration type is
Continuous on step #"
Notes: If “Duration Time” is set for the last step, the last step of ARB keeps playing
as if set to “Continuous” after set time expires. However, you can query
Source Sweeping Condition Message (:STAT:OPER:COND?) to find out if
the current list sequence is complete or not.
Preset: 1.00 ms
Min: 100 μs
Max: 1800 s
Initial S/W Revision: A.05.00