Filter
Top Products
11 76
Source (Internal)
Load All To ARB Memory
Allows you to load all the segment files within the currently selected directory into ARB memory. If a file of the
same name already exists within ARB memory, it is overwritten. If you wish to load two segments of the same
name, you must rename one of the segments before loading it into ARB memory. To rename a segment, you can
either use Windows File Explorer, or the :MEMory:COPY command.
Notes: <string> - specifies the path name of the file to load from the HDD into ARB
memory. It could be a <full path + filename>, or <“NVWFM” MSUS + colon
+ filename>.
When in Sequence Analyzer mode, and Include Source is Yes, an attempt to
load a file to ARB memory will be rejected with an error.
When Include Source is Noand if there is insufficient free ARB memory to
load the selected waveform, an error is generated. .
If you specify a file over SCPI, but the file is not at the specified location, an
error is generated.
If you try to load a waveform file but the file contains less than 500 IQ
sampes, an error is generated.
If you try to load a Signal Studio waveform “*.wfm” which contains invalid
waveform header, an error is generated.
If the ARB is ON when you load afile to ARB memory or delete a file from
ARB memory, the playing waveform segment may not keep phase continuity
during the ARB memory operation. The waveform will be replayed after the
ARB operation is finished.
ARB can be loaded into ARB memory even required licenses do not present
on the instrument. In this case, a GUI only warning message –800, “Operation
complete; Loaded <filename> successfully, but no license <required licenses>
installed”. User can install required licenses according to <required licenses>
string to license it, or multi-pack license it.
Initial S/W Revision: A.05.00
Key Path:
Source, Modulation Setup, ARB, Select Waveform, Segments on Hard
Disk
Remote Command: :SOURce:RADio:ARB:LOAD:ALL <string>
Example: SOUR:RAD:ARB:LOAD:ALL “D:\nvarb”