Filter
Top Products
1248
Source (Internal)
Output Trigger
Allows you to specify the trigger output for the current step. The trigger output signal is sent at the start
of the step.
When select “On”, trigger event will occur on both Internal and External2 paths. Select “Off” will turn
off trigger output.
Step Configuration (Remote Command Only)
This SCPI command is used to configure the List Sequencer and is detailed in the table below. The
command is defined such that you send one command per step, with the step number being specified as a
subopcode of the SCPI command. Each command includes all the parameter settings for the step. As a
step is setup, the values entered are run through several levels of validation.
Key Path: Source, List Sequencer, List Sequencer Setup
Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:OUTPut:TRIGger
ON|OFF|1|0
:SOURce:LIST:STEP[1]|2|3…1000:SETup:OUTPut:TRIGger
Example: SOUR:LIST:STEP2:SET:OUTP:TRIG ON
SOUR:LIST:STEP2:SET:OUTP:TRIG?
Notes: SCPI is supported after A.09.40
Preset: Off
Range: On|Off
Initial S/W Revision: A.05.00
Remote Command: :SOURce:LIST:STEP[1]|2|3|4..1000:SETup
IMMediate|INTernal|KEY|BUS|EXTernal2, <time>,
NONE|PGSM|EGSM|RGSM|DCS1800|PCS1900|TGSM810|GSM450|GSM4
80|GSM700|GSM850|BANDI|BANDII|BANDIII|BANDIV|BANDV|BAND
VI|BANDVII|BANDVIII|BANDIX|BANDX|BANDXI|BANDXII|BANDXII
I|BANDXIV|USCELL|USPCS|JAPAN|KOREAN|NMT|IMT2K|UPPER|SEC
OND|PAMR400|PAMR800|IMTEXT|PCS1DOT9G|AWS|US2DOT5G|PUBLI
C|LOWER|NONE|BAND1|BAND2|BAND3|BAND4|BAND5|BAND6|BAND7|
BAND8|BAND10|BAND11|BAND12|BAND13|BAND14|BAND17|BAND18|
BAND19|BAND20|BAND21|BAND24|BAND25|BAND33|BAND34|BAND35
|BAND36|BAND37|BAND38|BAND39|BAND40|BAND41|BAND42|BAND4
3|BANDA|BANDB|BANDC|BANDD|BANDE|BANDF, DOWN|UP, <freq>,
<ampl>, <string>, TIME|COUNt|CONTinuous, <time>,
ON|OFF|1|0, [<int>],
:SOURce:LIST:STEP[1]|2|3|4..1000:SETup?
Example: SOUR:LIST:STEP1:SET INT, 1ms, PGSM, DOWN, 10, –25 dBm,
“GSM_Test1.bin”, TIME, 10ms, OFF, 255