Filter
Top Products
11 27
Save
Save
Most of the functions under this key work the same way in many measurements, so they are documented
in “Save” on page 204.
The Amplitude Correction function under Save is documented here.
Amplitude Correction
Pressing this key selects Amplitude Corrections as the data type to be exported. Pressing this key again
brings up the Select Menu, which allows the user to select which Amplitude Correction to save.
Amplitude Corrections are fully discussed in the documentation of the Input/Output key, under the
Corrections softkey.
Correction Data File
A Corrections Data File contains a copy of one of the test set correction tables. Corrections provide a
way to adjust the trace display for predetermined gain curves (such as for cable loss).
Key Path: Save
Remote Command: :MMEMory:STORe:CORRection 1|2|3|4|5|6, <filename>
Example: :MMEM:STOR:CORR 2 "myAmpcor.csv" saves Correction 2 to the file
myAmpcor.csv on the current path.
The default path is My Documents\amplitudeCorrections.
Notes: If the save is initiated via SCPI, and the file already exists, the file will be
overwritten.
Using the C: drive is strongly discouraged, since it runs the risk of being
overwritten during an instrument software upgrade.
Both single and double quotes are supported for any filename parameter over
SCPI.
Dependencies: Corrections are not supported by all Measurements. If in a Mode in which
some Measurements support it, this key will be grayed out in measurements
that do not. The key will not show at all if no measurements in the Mode
support it.
This key will not appear unless you have the proper option installed in your
instrument.
Readback: Selected Correction
Backwards Compatibility SCPI: :MMEMory:STORe:CORRection ANTenna|CABLe|OTHer|USER,
<filename>
For backwards compatibility, ANTenna maps to 1, CABle maps to 2, OTHer
maps to 3 and USER maps to 4
Initial S/W Revision: A.02.00