Filter
Top Products
413
ACP Measurement
Meas Setup
Measurement Noise Bandwidth
Specifies the Measurement Noise Bandwidth used to calculate the power in the carriers.
Each Measurement Noise Bandwidth value is entered individually by selecting the desired carrier on the
carrier menu key using the up down arrows, the knob, or the numeric keypad. Then enter the
measurement noise bandwidth using the measurement noise bandwidth key.
Remote Command [:SENSe]:ACPower:CARRier[1]|2:LIST:WIDTh <bandwidth>, …
[:SENSe]:ACPower:CARRier[1]|2:LIST:WIDTh?
Example ACP:CARR2:LIST:WIDT 25kHz
ACP:CARR2:LIST:WIDT?
Notes Carrier sub op code. 1 for BTS, 2 for MS. Default is BTS.
When setting these values remotely, the position in the list sent corresponds to
the carrier. Missing values are not permitted, therefore if you want to change
values 2 and 6 you must send all values up to 6. Subsequent values will
remain unchanged, unless the number of values sent is greater than the
number of carriers, then subsequent values will be ignored.
You must be in the mode that includes ACP measurements to use this
command. Use :INSTrument:SELect to set the mode.
Couplings Coupled to the number of carriers. When the SCPI command is sent, the
number of carriers will be set to the number of entries in the parameter list.
Changing Carrier Spacing might affect the Span.
Preset WCDMA: 5 MHz
WIMAX OFDMA: 10 MHz
C2K: 1.25 MHz
1xEVDO: 1.25 MHz
TD-SCDMA: 1.6 MHz
LTE: 5 MHz
LTETDD: 5 MHz
State Saved Saved in instrument state.
Min 0 Hz
Max 1 GHz
Backwards Compatibility SCPI [:SENSe]:MCPower:CARRier[1]|2:LIST:WIDTh (PSA Power Suite)
Initial S/W Revision Prior to A.02.00
Modified at S/W Revision A.02.00, A.03.00
Key Path
Meas Setup, Carrier Setup, Configure Carriers
Mode WCDMA, C2K, WIMAX OFDMA, TD-SCDMA, 1xEVDO, LTE, LTETDD