Filter
Top Products
412
ACP Measurement
Meas Setup
The query for this parameter returns the current values for all of the carriers. If a carrier is defined as
having no power present, the power displayed will be relative to the reference carrier, otherwise the
absolute power will be displayed.
If you change the carrier power present to no and that carrier is currently configured as the reference
carrier, the next carrier to the left (or the right if there are no carriers to the left) will be assigned as the
reference carrier. This also applies to the scenario where there are only two carriers configured as having
power present and you configure only one carrier to have no power present.
Carrier Spacing
Sets the width of the carrier spacing. This will be the value applied to all the current slots, whether they
are carriers or spaces.
Enter each carrier spacing value individually by selecting the desired carrier on the carrier menu key
using the up down arrows, the knob, or the numeric keypad, then enter the carrier width using the carrier
spacing menu key.
Key Path Meas Setup, Carrier Setup, Configure Carriers
Mode WCDMA, C2K, WIMAX OFDMA, 1xEVDO, TD-SCDMA, LTE, LTETDD
Remote Command [:SENSe]:ACPower:CARRier[1]|2:LIST:PPResent YES|NO, …
[:SENSe]:ACPower:CARRier[1]|2:LIST:PPResent?
Example ACP:CARR2:LIST:PPR YES
ACP:CARR2:LIST:PPR?
Notes Carrier sub op code. 1 for BTS, 2 for MS. Default is BTS.
When setting these values remotely, the position in the list sent corresponds to
the carrier. Missing values are not permitted, therefore if you want to change
values 2 and 6 you must send all values up to 6. Subsequent values will
remain unchanged, unless the number of values sent is greater than the
number of carriers, then subsequent values will be ignored.
Dependencies If there is only one carrier, this key will be grayed out.
Couplings Coupled to the number of carriers. When the SCPI command is sent, the
number of carriers will be set to the number of entries in the parameter list.
Preset YES
State Saved Saved in instrument state.
Range Yes|No
Backwards Compatibility SCPI [:SENSe]:MCPower:CARRier[1]|2:LIST:PPResent (PSA Power Suite)
Initial S/W Revision Prior to A.02.00
Modified at S/W Revision A.02.00, A.03.00
Key Path
Meas Setup, Carrier Setup, Configure Carriers
Mode WCDMA, C2K, WIMAX OFDMA, 1xEVDO, TD-SCDMA, LTE, LTETDD