Filter
Top Products
978
Input/Output
Delete Correction
Deletes the correction values for this set. When this key is pressed a prompt is placed on the screen that says
“Please press Enter or OK key to delete correction. Press ESC or Cancel to close this dialog.” The deletion is only
performed if you press OK or Enter.
Correction On/Off
Apply Corrections
Applies amplitude corrections which are marked as ON to the measured data. If this is set to OFF, then no
amplitude correction sets will be used, regardless of their individual on/off settings. If set to ON, the corrections
that are marked as ON (see “Correction On/Off” on page 959) are used.
Delete All Corrections
Erases all correction values for all 16 Amplitude Correction sets.
When this key is pressed a prompt is placed on the screen that says “Please press Enter or OK key to delete all
Initial S/W Revision: A.10.00
Key Path:
Input/Output, RF Output & Test Set Config, Multiport Adapter,
Corrections
Remote Command: [:SENSe]:MPADapter:CORRection:CSET[1]|2|3|4|5|6|7|8|9|1
0|11|12|13|14|15|16:DELete
Example: MPAD:CORR:CSET:DEL
MPAD:CORR:CSET1:DEL
MPAD:CORR:CSET4:DEL
Notes: Pressing this key when no corrections are present is accepted without error.
Initial S/W Revision: A.10.00
Key Path:
Input/Output, RF Output & Test Set Config, Multiport Adapter,
Corrections
Remote Command: [:SENSe]:MPADapter:CORRection:CSET:ALL[:STATe]
ON|OFF|1|0
[:SENSe]:MPADapter:CORRection:CSET:ALL[:STATe]?
Example: SENS:MPAD:CORR:CSET:ALL OFF
This command makes sure that no amplitude corrections are applied,
regardless of their individual on/off settings.
Preset: Not affected by Preset. Set to OFF by Restore Input/Output Defaults
State Saved: Saved in instrument state.
Initial S/W Revision: A.10.00