11 86
Source (Internal)
using the :SOURce:RADio:ARB:TRIGger:INITiate command.
External 2
Sets the current trigger source to External 2. Selecting External 2 enables triggering a waveform by an externally
applied signal.
Trigger Initiate
Used to initiate an immediate trigger event if the trigger source is set to Trigger Key.
Waveform Sequences
Allows access to the waveform sequence sub-menus. Pressing this key changes the central view area to
display the Waveform Sequence List view.
Build New Sequence
Allows access to the sub-menus for creating a new waveform sequence. Pressing this key changes the central view
area to display the Waveform Sequence Creation and Editing view.
Key Path:
Source, Modulation Setup, ARB, Trigger Source
Example: SOUR:RAD:ARB:TRIGger BUS
Initial S/W Revision: A.05.00
Key Path:
Source, Modulation Setup, ARB, Trigger Source
Example: SOUR:RAD:ARB:TRIGger EXT2
Initial S/W Revision: A.05.00
Key Path:
Source, Modulation Setup, ARB
Notes: No remote command, SCPIfront panel only.
Initial S/W Revision: A.05.00
Key Path:
Source, Modulation Setup, ARB
Notes: No remote command, SCPI front panel only.
Initial S/W Revision: A.05.00
Key Path:
Source, Modulation Setup, ARB, Waveform Sequences
Notes: No remote command, SCPIfront panel only.
Initial S/W Revision: A.05.00