Filter
Top Products
248
System Functions
System
External Mixer and return a success or failure value.
Source
This menu is only available in the EXT (E6607A).
Accesses source alignment processes that are immediate action operations. They perform complete
operations and run until they are complete.
Immediately executes an IQ alignment of the complete source. The instrument stops any sequence of the
source, performs the alignment, then restarts the sequence from the beginning.
There is no alert available for the source alignment. The operators have the responsibility to check
temperature shift since last Align Now, Source to determine if the source alignment need to be executed.
Key Path: System, Alignments, Align Now
Mode: All
Remote Command: :CALibration:EMIXer
:CALibration:EMIXer?
Example: :CAL:EMIX
Notes: :CAL:EMIX? returns 0 if successful
:CAL:EMIX? returns 1 if failed
While Align Now, Ext Mix is performing the alignment, bit 0 in the Status
Operation register is set. Completion, or termination, will clear bit 0 in the
Status Operation register.
This command is sequential; it must complete before further SCPI commands
are processed. Interrupting the alignment from remote is accomplished by
invoking Device Clear followed by the :ABORt command.
A failure encountered during alignment will generate the Error Condition
message “Align LO failed” and set bit 5 in the Status Questionable Calibration
register. Successful completion will clear the “Align LO failed” message and
bit 5 in the Status Questionable Calibration register.
Dependencies: This key does not appear unless option EXM is present and is grayed-out
unless a USB mixer is plugged in to the USB.
Status Bits/OPC dependencies: Bit3 may be set in the Status Questionable Calibration Extended Failure
register.
Initial S/W Revision: A.08.00
Key Path:
System, Alignments, Align Now
Mode: All
Remote Command: :CALibration:INTernal:SOURce[:ALL]
:CALibration:INTernal:SOURce[:ALL]?
Example: :CAL:INT:SOUR