Filter
Top Products
981
Input/Output
Off
Selects no signal to be output to the Trig 1 Out or Trig 2 Out connector.
Polarity
Sets the output to the Trig 1 Out or Trig 2 Out connector to trigger on either the positive or negative
polarity.
Dependencies: The second Trigger output (Trig 2 Out) does not appear in all models; in
models that do not support it, the Trig 2 Out key is blanked, and sending the
SCPI command for this output generates an error, “Hardware missing; Not
available for this model number” In models that do not support the Trigger 2
output, this error is returned if trying to set Trig 2 Out and a query of Trig 2
Out returns OFF.
Dependencies: SSWeep|SSETtled|S1Marker|S2Marker|S3Marker|S4Marker are only
available for the source in the EXT.
Preset: Trigger 1: Sweeping (HSWP)
Trigger 2: Gate
This is unaffected by a Preset but is preset to the above values on a "Restore
Input/Output Defaults" or "Restore System Defaults->All"
State Saved: Saved in instrument state
Initial S/W Revision: Prior to A.02.00
Key Path:
Input/Output, Output Config, Trig 1/2 Output
Example: TRIG1:OUTP OFF
Readback: Off
Initial S/W Revision: Prior to A.02.00
Key Path:
Input/Output, Output Config, Trig 1/2 Output
Remote Command: :TRIGger|TRIGger1|TRIGger2[:SEQuence]:OUTPut:POLarity
POSitive|NEGative
:TRIGger|TRIGger1|TRIGger2[:SEQuence]:OUTPut:POLarity?
Example: TRIG1:OUTP:POL POS
Preset: This is unaffected by a Preset but is set to POSitive on a "Restore Input/Output
Defaults" or "Restore System Defaults->All"
State Saved: Saved in instrument state
Initial S/W Revision: Prior to A.02.00