Filter
Top Products
11 93
Source (Internal)
Notes: For Setup SCPI
For the Setup SCPI command, the parameters are:
<filename> - String Type
This variable specifies the path and name for the waveform sequence file. The
path supports MSUS (NVWFM) or a real full path representation. See
example.
<waveform1> - String Type
This variable specifies the path and name of the first existing waveform
segment. The path supports MSUS (NVWFM) or a real full path
representation. See example.
The segment file must reside within ARB playback memory before it can be
played by the ARB player.
<reps> - Integer Type
This variable specifies the number of times a segment or sequence plays
before moving on to the next segment or sequence.
<marker> - Enum Type
NONE – This choice disables all four markers for the waveform. Disabling
markers means that the waveform sequence ignores the segments or sequence
marker settings.
M1, M2, M3, M4 – these choices, either individually or a combination of
them, enable the markers for the waveform segment or sequence. Markers not
specified are ignored for that segment or sequence.
ALL – This choice enables all four markers in the waveform segment or
sequence.
<waveform2> - String type.
This variable specifies the name of a second existing waveform segment. The
path supports MSUS (NVWFM) and real full path representation both. See
example.
The segment file must reside within ARB playback memory before it can be
played by the ARB player.
<reps> same as above, for the 2
nd
waveform segment.
<marker> same as above, for the 2
nd
waveform segment.
You can insert several waveform segments into a waveform sequence file. Just
repeat inserting waveform segments as described above.
Error Checks for Setup SCPI command:
If you do not specify a filename, or you use an unsupported MSUS (that is, not
NVWFM), or have an error in the waveform sequence file path, an error is
generated.