Filter
Top Products
1251
Source (Internal)
Step Configuration of Radio Band parameter list (Remote Command Only)
This SCPI command is to configure “Radio Band” parameter array of the whole List Sequencer at one time. The
number of array is same as step number defined in “Number of Steps” on page 1221 Number of Steps. As a step is
setup, the value entered run through several levels of validation.
Step Configuration of Radio Band Link parameter list (Remote Command Only)
This SCPI command is to configure “Radio Band Link” parameter array of the whole List Sequencer at one time.
The number of array is same as step number defined in “Number of Steps” on page 1221 Number of Steps. As a
Notes: The command is to setup below parameter array of whole list sequence.
Transition Time <time> - specifies the transition time for the stepin seconds.
For details of the valid ranges for the transition time see “Transition Time” on
page 1224
If input parameter number exceeds the step number defined by Number of
Steps then generate error ", and only those parametes whose index number
falls in number of steps will be updated.
Dependencies: The range is 1 to 1000 which is determined by the number of steps you have
configured. For details see “Number of Steps” on page 1221.
Initial S/W Revision: A.09.40
Remote Command: :SOURce:LIST:SETup:RADio:BAND <enum>, <enum>, <enum>, …
:SOURce:LIST:SETup:RADio:BAND?
Example: SOUR:LIST:SET:RAD:BAND PGSM, EGSM, RGSM
SOUR:LIST:SET:RAD:BAND?
Notes: The command is to setup below parameter array of whole list sequence.
Radio Band <enum> - specifies the radio band for the step. For details of the
valid radio bands see “Radio Setup” on page 1225.
If input parameter number exceeds the step number defined by Number of
Steps then generate error ", and only those parametes whose index number
falls in number of steps will be updated.
Remote Command Notes: NONE|PGSM|EGSM|RGSM|DCS1800|PCS1900|TGSM810|GSM450|GSM4
80|GSM700|GSM850|BANDI|BANDII|BANDIII|BANDIV|BANDV|BAND
VI|BANDVII|BANDVIII|BANDIX|BANDX|BANDXI|BANDXII|BANDXII
I|BANDXIV|USCELL|USPCS|JAPAN|KOREAN|NMT|IMT2K|UPPER|SEC
OND|PAMR400|PAMR800|IMTEXT|PCS1DOT9G|AWS|US2DOT5G|PUBL
IC|LOWER|NONE|BAND1|BAND2|BAND3|BAND4|BAND5|BAND6|BA
ND7|BAND8|BAND10|BAND11|BAND12|BAND13|BAND14|BAND17|B
AND18|BAND19|BAND20|BAND21|BAND24|BAND25
Dependencies: The range is 1 to 1000 which is determined by the number of steps you have
configured. For details see “Number of Steps” on page 1221.
Initial S/W Revision: A.09.40