Filter
Top Products
676
Code Domain
Marker
Marker
Accesses a menu that enables you to select, set up and control the markers for the current measurement.
See the "Marker Functions" section for more information
Marker Symbol Value (Remote Command only)
Sets the marker symbol value in the current marker for the trace of I/Q symbol polar vector. It has no
effect if the control mode is
Off, but is the SCPI equivalent of entering an X value if the control mode is
Normal.
NOTE This command is only valid when Marker Trace is ‘POLar’ (I/Q symbol polar
vector). And, for other Marker Trace, it’s not valid and ignored.
Key Path Front Panel Key
Mode cdma2000
Remote Command :CALCulate:CDPower:MARKer[1]|2|3|4|5|6|7|8|9|10|11|1
2:SYMBol <real>
:CALCulate:CDPower:MARKer[1]|2|3|4|5|6|7|8|9|10|11|1
2:SYMBol?
Example CALC:CDP:MARK:SYMB 1.0
CALC:CDP:MARK:SYMB?
Restriction and Notes If no suffix is sent it uses ‘symbols’. If a suffix is not ‘symbols’, an error
“Invalid suffix” is generated.
The query returns the marker’s ‘symbol’ value in the trace if the control
mode is
Normal. The query is returned in ‘symbols’. If the marker is Off
the response is not a number.
The description provided in the MIN/MAX/DEF Support field is only for
the SCPI tester. The remote command supports all the MIN/MAX/DEF
parameters.
Remote Command Notes This parameter has different meaning between the cases where the
marker trace is set to Symbol I/Q Polar Vector and others. In the Symbol
I/Q Polar Vector Graph, X Axis Value is also the measured value, so this
parameter is meaningful only when the control mode is set to Normal
Preset Start point of the trace on the display window
State Saved No
Min –9.9E+37
Max 9.9E+37