Filter
Top Products
543
Spectrum Emission Mask Measurement
Meas Setup
Restart
See “Restart” on page 1125 for more information.
Save
See “Save” on page 204 for more information.
Data
See “Data (Export)” on page 213 for more information.
Measurement Results
Pressing this key selects Meas Results as the data type to be exported.
The Meas Results file contains information that describes the current state of the analyzer. It is detailed
in “Meas Results File Contents” on page 544 below.
Initial S/W Revision: Prior to A.02.00
Key Path:
Front-panel key
Initial S/W Revision: Prior to A.02.00
Key Path:
Front-panel key
Initial S/W Revision: Prior to A.02.00
Key Path:
Front-panel key
Key Path: Save, Data
Remote Command: :MMEMory:STORe:RESults <string>
Example: :MMEM:STOR:RES “MeasR_0000.csv”
Notes: If the save is initiated via SCPI and the file already exists, the file will be
overwritten.
The SCPI command exports Spectrum Emission Mask measurement results to
the file specified as the parameter in the current path. The default path is My
Documents\<current mode>\data\SEM\results.
Using the C: drive is strongly discouraged, since it runs the risk of being
overwritten during an instrument software upgrade.
The SCPI parameter is a quoted string that specifies the filename. Both single
and double quotes are supported for any filename parameter over SCPI.
Dependencies: The current active measurement must be the Spectrum Emission Mask
measurement to use this command.
Status Bits/OPC dependencies: Sequential – waits for the previous measurement to complete