Filter
Top Products
952
Input/Output
or source.
Input Port
Specifies the multiport adapter unit input port used.
OFF
Specifies using the multiport adapter input port OFF.
Key Path:
Input/Output, RF Output & Test Set Config, Multiport Adapter
Remote Command: [:SENSe]:MPADapter[:STATe] ON|OFF|1|0
[:SENSe]:MPADapter[:STATe]?
Example: :MPAD ON
Dependencies: Only when the multiport adapter unit is connected to the EXT by USB, it is
appeared. Otherwise, it will not be displayed and set to OFF.
If the current RF Input port is not RF Input, turn Multiport Adapter to On , an
error message is generated: “–221, Settings conflict; RFIO1 or RFIO2 Port
unavailable when Multiport Adapter is ON”.
Preset: This is unaffected by Mode Preset but is set to OFF on a "Restore
Input/Output Defaults" or "Restore System Defaults -> All"
Initial S/W Revision: A.10.00
Key Path:
Input/Output, RF Output & Test Set Config, Multiport Adapter
Remote Command: [:SENSe]:MPADapter:PORT:INPut OFF|RFIO0| RFIO1| RFIO2|
RFIO3| RFIO4| RFIO5| RFIO6| RFIO7
[:SENSe]:MPADapter:PORT:INPut?
Example: :MPAD:PORT:INP RFIO1
Dependencies: This menu selection does not have any effect unless Input/Output, More, RF
Output & Test Set Config, Multiport Adapter is set to the On state.
Preset: This is unaffected by Mode Preset but is set to RFIO0 on a "Restore
Input/Output Defaults" or "Restore System Defaults -> All"
State Saved: Saved in State
Readback Text: The current Multiport Adapter Input Port selected is read back to this key
Backwards Compatibility SCPI
Notes:
The commands above are included for ESU compatibility
Initial S/W Revision: A.10.00
Key Path:
Input/Output, RF Output & Test Set Config, Multiport Adapter, Input Port
Example: [:SENSe]:MPADapter:PORT:INPut OFF