Filter
Top Products
615
Occupied Bandwidth Measurement
Meas Setup
Meas Setup
Displays the setup menu for the current measurement. The measurement setup parameters include the
number of measurement averages used to calculate the measurement result and the averaging mode. The
setup menu also includes the option to reset the measurement settings to their factory defaults.
Avg/Hold Num
Specifies the number of measurement averages used when calculating the measurement result. The
average is displayed at the end of each sweep.
Initiates an averaging routine that averages the sweep points in a number of successive sweeps, resulting
in trace smoothing.
After the specified number of average counts, the average mode (termination control) setting determines
the average action.
Key Path: Front-panel key
Initial S/W Revision: Prior to A.02.00
Key Path:
Meas Setup
Mode: WCDMA, C2K, WIMAX OFDMA, TD-SCDMA, 1xEVDO, LTE, LTETDD,
BLUETOOTH, WLAN
Remote Command: [:SENSe]:OBWidth:AVERage:COUNt <integer>
[:SENSe]:OBWidth:AVERage:COUNt?
[:SENSe]:OBWidth:AVERage[:STATe] ON|OFF|1|0
[:SENSe]:OBWidth:AVERage[:STATe]?
Example: OBW:AVER:COUN 1500
OBW:AVER:COUN?
OBW:AVER ON
OBW:AVER?
Notes: You must be in the W-CDMA mode, cdma2000 mode, TD-SCDMA mode,
BLUETOOTH mode, LTE mode, LTE TDD mode, WLAN mode, 1xEVDO
mode, or WIMAX OFDMA mode to use this command.
Use:INSTrument:SELect to set the mode.
Couplings: None
Averaging state is coupled to Max Hold. If Max Hold is changed from Off to
On, Averaging state is automatically set to On.
Preset: 10
ON