Filter
Top Products
932
Input/Output
Data Source
Gives you the choice of either using a hardware input signal as the input or raw data stored in a data
storage buffer from an earlier acquisition. You can also share raw data across certain measurements that
support this feature. The measurements must be capable of storing raw data. There are three choices
under this menu. You can select "Inputs" which is the same as selecting one of the inputs from the input
port, for example RF, AREF, I/Q, or IFALign. Selecting "Capture Buffer" allows you to use data that has
been stored earlier in the same measurement or from a previous measurement using the "Current Meas
-> Capture Buffer" feature. Selecting "Recorded Data" allows you to playback long data capture records
stored in the record buffer.
Inputs
Sets the measurement to use the input selections (RF, AREF, I/Q)
Notes: Refer to the Utility Functions for information about Restore System Defaults
and the complete description of the :SYSTem:DEFault INPut: command.
Initial S/W Revision: Prior to A.02.00
Key Path:
Input/Output
Remote Command: [:SENSe]:FEED:DATA INPut|STORed
[:SENSe]:FEED:DATA?
Example: FEED:DATA STOR
FEED:DATA?
Notes: INPuts = Inputs
STORed = Capture Buffer
Dependencies: Not all inputs are available in all modes. Unavailable keys are grayed out.
Preset: This is unaffected by Preset but is set to INPut on a "Restore Input/Output
Defaults" or "Restore System Defaults->All"
State Saved: Saved in instrument state
Readback: Variable
Backwards Compatibility SCPI: [:SENSe]:FEED:SOURce INPut|STORed
[:SENSe]:FEED:SOURce?
Initial S/W Revision: Prior to A.02.00
Key Path:
Input/Output, Data Source
Example: FEED:DATA INP causes the measurement to look at the input selection
Notes: Does not auto return.