Filter
Top Products
498
Spectrum Emission Mask Measurement
Marker
the value of the marker.
Marker Y Axis Value (Remote Command Only)
Returns the marker Y Axis value in the current marker Y Axis unit.
Mode: WCDMA, C2K, WIMAX OFDMA, TD-SCDMA, 1xEVDO, LTE, LTETDD,
WLAN
Remote Command: :CALCulate:SEMask:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:X:
POSition <real>
:CALCulate:SEMask:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:X:
POSition?
Example: CALC:SEM:MARK10:X:POS 1001
CALC:SEM:MARK10:X:POS?
Notes: The query returns the marker’s absolute X Axis value in trace points if the
control mode is
Normal. The value is returned as a real number, not an integer,
corresponding to the translation from X Axis Scale units to trace points . If the
marker is
Off the response is not a number.
When a Marker is turned on, it is placed center of the screen on the trace.
Therefore the default value depends on the instrument condition although the
Preset/Default is defined as 6507 (this value might be the expected value
when all the offsets are on).
Preset: After a preset, all Markers are turned OFF, so a Marker X Axis Value query
will return a not a number (NAN).
State Saved: No
Min: –9.9E+37
Max: 9.9E+37
Initial S/W Revision: Prior to A.02.00
Modified at S/W Revision: A.02.00, A.03.00
Mode: WCDMA, C2K, WIMAX OFDMA, TD-SCDMA, 1xEVDO, LTE, LTETDD,
WLAN
Remote Command: :CALCulate:SEMask:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:Y?
Example: CALC:SEM:MARK11:Y 10 dBm
CALC:SEM:MARK11:Y?
Notes: Since the result value is always calculated from acquisition data, the default
value is arbitrary, although the Preset/Default values is defined.
Preset: Result dependent on markers setup and signal source
State Saved: No