Filter
Top Products
1029
Marker To
Mkr->Stop
Changes the stop frequency to the frequency of the selected marker. The marker stays at this frequency,
so it moves to the right edge of the display. In delta marker mode, this function sets the stop frequency to
the x-axis value of the delta marker.
If the currently selected marker is not on when this key is pressed, it is turned on at the center of the
screen as a normal type marker.
MkrΔ->Span
Sets the start and stop frequencies to the values of the delta markers. That is, it moves the lower of the
two marker frequencies to the start frequency and the higher of the two marker frequencies to the stop
frequency. The marker mode is unchanged and the two markers (delta and reference) end up on opposite
edges of the display.
Initial S/W Revision Prior to A.02.00
Key Path
Marker ->
Remote Command :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12[:SET]:STO
P
Example CALC:MARK3:STOP sets the stop frequency to the value (or delta value) of
marker 3.
Notes Sending this command selects the subopcoded marker
If specified marker is off, this command will turn it on at the center of the
screen as a normal type marker.
Dependencies This function is not available (key is grayed out) when x-axis is the time
domain
Couplings All the usual couplings associated with setting Stop Frequency apply (see the
Frequency Section).
Initial S/W Revision Prior to A.02.00
Key Path
Marker ->
Remote Command :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12[:SET]:DEL
Ta:SPAN
Example CALC:MARK2:DELT:SPAN sets the start and stop frequencies to the values
of marker 2 and its reference marker.
Notes Sending this command selects the subopcoded marker
Dependencies This function is only available when the selected marker is a delta marker.
Otherwise the key is grayed out.
In addition, this function is not available when x-axis is the time domain