Filter
Top Products
1318
Trace/Detector
Peak / Average / NPeak
This is a setting for making a measurement of the average power and the signal envelope.
Peak / Sample / NPeak
This is a setting for making a measurement that displays a power sample and the signal envelope.
Clear Trace
Clears the selected trace (from the front panel) or the specified trace (from SCPI). Does not affect the
state of any function or variable in the instrument. Loads mintracevalue into all of the points in the
selected trace, unless the trace is in Min Hold in which case it loads maxtracevalue. It does this even if
Update = Off.
This key only appears in the Normal View. It does not appear when in the Spectrogram View.
Clear All Traces
Clears all traces. Does not affect the state of any function or variable in the instrument. Loads
mintracevalue into all of the points all traces, except traces in Min Hold in which case it loads
maxtracevalue. Does so even if Update = Off.
This key only appears in the Normal View. It does not appear when in the Spectrogram View.
Couplings Trace 1: Set to peak detection, and Clear-Write.
Trace 2: Set to average detection, and Clear-Write.
Trace 3: Set to negative peak detection, and Clear-Write.
Initial S/W Revision Prior to A.02.00
Couplings Trace 1: Set to peak detection, and Clear-Write.
Trace 2: Set to sample detection, and Clear-Write.
Trace 3: Set to negative peak detection, and Clear-Write.
Initial S/W Revision Prior to A.02.00
Key Path
Trace/Detector
Remote Command :TRACe:CLEar TRACE1|TRACE2|TRACE3|TRACE4|TRACE5|TRACE6
Example TRAC:CLE TRACE1 clears trace 1
Initial S/W Revision Prior to A.02.00
Key Path
Trace/Detector
Remote Command :TRACe:CLEar:ALL
Example TRAC:CLE:ALL clears all traces