Filter
Top Products
1240
Source (Internal)
BAND F
Selects BAND F as the band for the current step.
Radio Band Link
Allows you to specify the radio band link direction for the steps within the list sequence. The link is used in
conjunction with the channel band and channel number to determine the output frequency.
When set to “Uplink”, the source will calculate the uplink frequency according to an uplink formula together with
selected channel band and channel number. When set to “Downlink”, the source will calculate the downlink
frequency according to a downlink formula together with selected channel band and channel number.
Channel
Allows you to specify the frequency of the current step via a channel number.
Key Path: Source, List Sequencer, List Sequencer Setup, Radio Setup, Radio
Standard, TDSCDMA
Initial S/W Revision: A.11.50
Key Path:
Source, List Sequencer, List Sequencer Setup, Radio Setup
Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:RADio:BAND:LINK
DOWN|UP
:SOURce:LIST:STEP[1]|2|3…1000:SETup:RADio:BAND:LINK?
Example: SOUR:LIST:STEP2:SET:RAD:BAND:LINK UP
SOUR:LIST:STEP2:SET:RAD:BAND:LINK?
Notes: SCPI is supported after A.09.40
Preset: DOWN
Range: DOWN | UP
Initial S/W Revision: A.05.00
Key Path:
Source, List Sequencer, List Sequencer Setup
Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:CNFRequency
<double>
:SOURce:LIST:STEP[1]|2|3…1000:SETup:CNFRequency?
Example: SOUR:LIST:STEP2:SET:CNFR 124
SOUR:LIST:STEP2:SET:CNFR?
Notes: SCPI is supported after A.09.40.
This SCPI is used to setup channel number or frequency setting, according to
current Radio Band setting. If Radio Band is “NONE”, then it’s frequency. If
Radio Band is not “NONE”, then it’s channel number.