Filter
Top Products
960
Input/Output
Properties
Accesses a menu that lets you set the properties of the selected correction.
Select Correction
Specifies the selected correction. The term "selected correction" is used throughout this document to specify which
correction will be affected by the functions.
Dependencies: This menu selection does not have any effect unless Input/Output, More, RF
Output & Test Set Config, Multiport Adapter, Multiport Adapter is set to the
On state. This menu selection is hidden if the currently active measurement or
mode does not support amplitude correction.
Turning this on automatically turns on "Apply Corrections"
Only the first correction array (Correction 1) supports antenna units. When
this array is turned on, and it contains an Antenna Unit other than “None”, the
Y Axis Unit of the analyzer is forced to that Antenna Unit. All other Y Axis
Unit choices are grayed out.
Note that this means that a correction file with an Antenna Unit can only be
loaded into the Corrections 1 register. Consequently only for Correction 1
does the dropdown in the Recall dialog include.ant, and if an attempt is made
to load a correction file into any other Correction register which DOES
contain an antenna unit, a Mass Storage error is generated.
This command will generate an “Option not available” error unless you have
the proper option installed in your instrument.
Preset: Not affected by a Preset. Set to OFF by
Restore Input/Output Defaults
State Saved: Saved in instrument state.
Initial S/W Revision: A.10.00
Key Path:
Input/Output, RF Output & Test Set Config, Multiport Adapter,
Corrections
Dependencies: This menu selection does not have any effect unless Input/Output, RF Output
& Test Set Config, Multiport Adapter, Multiport Adapter is set to the On state.
This menu selection is hidden if the currently active measurement or mode
does not support amplitude correction.
Initial S/W Revision: A.10.00
Key Path:
Input/Output, RF Output & Test Set Config, Multiport Adapter,
Corrections, Properties
Notes: The selected correction is remembered even when not in the correction menu
Dependencies: This menu selection does not have any effect unless Input/Output, RF Output
& Test Set Config, Multiport Adapter, Multiport Adapter is set to the On state
Preset: Set to Correction 1 by Restore Input/Output Defaults.