Filter
Top Products
740
Modulation Accuracy (Composite Rho)
Marker
Marker Y Axis Value (Remote Command only)
Queries the marker Y Axis value in the current unit for the marker Y Axis.
Properties
Accesses a menu that enables you to select a reference marker and marker trace.
Remote Command :CALCulate:RHO:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:X:
POSition <real>
:CALCulate:RHO:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:X:
POSition?
Example CALC:RHO:MARK10:X:POS 0.0
CALC:RHO:MARK10:X:POS?
Restriction and Notes The query returns the marker’s absolute X Axis value in trace points if
the control mode is
Normal, or the offset from the marker’s reference
marker in trace points, if the control mode is
Delta. The value is returned
as a real number, not an integer, corresponding to the translation from X
Axis Scale units to trace points (see “Fractional Trace Points”, above). If
the marker is
Off the response is not a number (NAN).
Remote Command Notes This command is not available when Marker Trace of the selected marker
(:CALCulate:RHO:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:TRACe?) is set
to POLar. In this case, this command is ignored.
Preset After a preset, all Markers are turned OFF, so Marker X Axis Value
query will return a not a number (NAN).
State Saved No
Min –9.9E+37
Max 9.9E+37
Mode cdma2000
Remote Command :CALCulate:RHO:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:Y?
Example CALC:RHO:MARK11:Y?
Restriction and Notes If no suffix is sent, the current Y Axis unit will be used. If a suffix is sent
that is not expressed in units of absolute amplitude, an “Invalid suffix”
error will be generated.
The query returns the marker Y-axis result if the control mode is
Normal
or
Delta. If the marker is Off the response is not a number (NAN).
Preset Result dependent on Markers setup and signal source
State Saved No
Key Path
Marker