Filter
Top Products
155
About the Test Set
Window Control Keys
Next Window
Selects the next window of the current view.When the Next Window key is pressed, the next window in
the order of precedencebecomes selected. If the selected window was zoomed, the next window will
also be zoomed.
The window numbers are as follows. Note that these numbers also determine the order of precedence
(that is, Next Window goes from 1 to 2, then 2 to 3, etc.):
One and only one window is always selected. The selected window has the focus; this means that all
window-specific key presses apply only to that window. You can tell which window is selected by the
thick green border around it. If a window is not selected, its boundary is gray.
If a window in a multi-window display is zoomed it is still outlined in green. If there is only one window,
the green outline is not used. This allows the user to distinguish between a zoomed window and a display
with only one window.
The selected window is local to each Measurement. Each Measurement remembers which window is
selected. The selected window for each Measurement is remembered in Mode state.
Remote Command: :DISPlay:WINDow:FORMat:ZOOM
Remote Command: :DISPlay:WINDow:FORMat:TILE
Example: :DISP:WIND:FORM:ZOOM sets zoomed
:DISP:WIND:FORM:TILE sets un-zoomed
Preset: TILE
Initial S/W Revision: Prior to A.02.00
Remote Command: :DISPlay:WINDow[:SELect] <number>
:DISPlay:WINDow[:SELect]?
Example: :DISP:WIND 1
Preset: 1
Min: 1
Max: If <number> is greater than the number of windows, limit to <number of
windows>
Initial S/W Revision: Prior to A.02.00