Filter
Top Products
514
Spectrum Emission Mask Measurement
Meas Setup
Offset/Limits
Accesses a menu that enables you to set up the measurement parameters for offset pairs. For example,
you can assign the start and stop frequencies, select the resolution bandwidth, and set the sweep time.
Select Offset
Selects the offset (upper and lower) and displays the memory selection menu that enables you to store a
set of parameter values for the offset, such as Start Freq, Stop Freq, Sweep Time, Res BW, Meas BW,
Abs Start, and Abs Stop. Only one selection at a time is shown on this menu key label.
Start Freq
Specifies the start frequency for the currently selected offset and enables you to toggle this function On
or Off for each offset.
State Saved: Saved in instrument state.
Min: –200
Max: 200
Initial S/W Revision: Prior to A.02.00
Modified at S/W Revision: A.02.00, A.03.00
Key Path:
Meas Setup
Initial S/W Revision: Prior to A.02.00
Key Path:
Meas Setup, Offset/Limits
Mode: WCDMA, C2K, WIMAX OFDMA, TD-SCDMA, 1xEVDO, LTE, LTETDD,
WLAN
Preset: A
Range: WLAN: A|B|C|D|E|F|G|H|I|J|K|L
Initial S/W Revision: Prior to A.02.00
Modified at S/W Revision: A.02.00, A.03.00, A.10.00, A.11.00
Key Path:
Meas Setup, Offset/Limits
Mode: WCDMA, C2K, WIMAX OFDMA, TD-SCDMA, 1xEVDO, LTE, LTETDD,
WLAN
Remote Command: [:SENSe]:SEMask:OFFSet[1]|2:LIST:FREQuency:STARt
<freq>, …
[:SENSe]:SEMask:OFFSet[1]|2:LIST:FREQuency:STARt?
[:SENSe]:SEMask:OFFSet[1]|2:LIST:STATe ON|OFF|1|0, …
[:SENSe]:SEMask:OFFSet[1]|2:LIST:STATe?