Filter
Top Products
273
System Functions
System
Date/Time
Enables you to configure the scheduler to run a task starting from this date and time. The date and time rely on the
instrument’s local time to execute a scheduled task. The date is based on the format “YYYY/MM/DD” and the
time is based on a 24 hour clock.
Notes: Changing the task will not reset the Scheduler time and the alignment is based
on the current scheduled configuration to occur.
For model N9038A only.
Preset: This is unaffected by Preset but is set to T3 on a “Restore System
Defaults->Align”.
State Saved: No
Range: Task 1 | Task 2 | Task 3
Initial S/W Revision: A.08.00
Key Path:
System, Alignments, RF Preselector, Schedule Setup
Mode: All
Remote Command: :CALibration:RFPSelector:SCHeduler:TIME:STARt
”date”,”time”
:CALibration:RFPSelector:SCHeduler:TIME:STARt?
This query returns data using the following format ”YYYY/MM/DD;
HH:MM:SS”
Example: :CAL:RFPS:SCH:TIME:STAR ”2009/8/20”,”12:00:00”
Notes: “date” is representation of the date the task will run in the form of
“YYYY/MM/DD” where:
YYYY is the four digit representation of year. (for example, 2009)
MM is the two digit representation of month. (for example, 01 to 12)
DD is the two digit representation of the day. (for example, 01 to 28, 29, 30 or
31 depending on the month and year)
“time” is a representation of the time of day the task will run in the form of
“HH:MM:SS” where:
HH is the two digit representation of the hour in 24 hour format
MM is the two digit representation of minute
SS is the two digit representation of seconds
For model N9038A only.
Preset: This is unaffected by Preset but is set to Current date and 00:00:00 on a
“Restore System Defaults->Align”.
State Saved: No
Initial S/W Revision: A.08.00