Filter
Top Products
6.4.5
6 - 85
(a) Specify a registration No. according to the setting of the Entry No. combo box.
(b) Enter a caption in the Caption box that will facilitate calling out measurement
parameters.
(c) Set the type of measurement and measurement mode corresponding to the
measurement to be executed.
(d) For auto measurement, set the measurement parameters or edge detection
parameters.
(e) Click the Apply button to apply the set measurement parameters to the process. At
the same time the parameters are saved under the set registration No.
(f) By putting a check at the Lock button, editing of the measurement parameters can be
inhibited.
(g) The Save button is used for calling out and editing the saved measurement
parameters and then saving them under a new registration No. Clicking this button
opens a window for specifying a registration No.
Fig. 6.4-16 Measurement Condition Save Window
Select a save destination No. and then click Save button.
(h) For deleting the saved measurement parameters, click the Delete button.
(i) When parameter editing and saving are finished, click the Close button to close the
Measurement Condition window.