Filter
Top Products
3.6 Saving and Recording Images
3 - 110
3.6.7.2 Captured Image Recording Using Buttons on the Captured Image Window
When images are captured, text and graphics shown on the image at the moment of starting
capture are memorized as the data for the captured image. The memorized data will be
recorded when the image is recorded using command buttons on the Captured Image window.
(1) To change entry data of the latest captured image, edit or add data and then click the
Update button on the Data Entry window. The memorized data for the captured image is
then replaced with the new data.
It is not possible if the image has been refreshed by RUN operation.
(2) During a capture process, if data input is performed either to add or change data while the
image is being displayed (with a CAP number displayed in yellow on the upper left edge of
the image), and then if the image is saved (Direct Save) from either the menu or the Control
Panel, photographed, printed, or sent to a PC, the data that is added will be added as data
on the captured image.
(3) When the Embed into Image checkbox on Record tab of Setup dialog window is checked,
Auto Data Display on the bottom of the image is memorized for the captured image at the
moment of starting capture. The memorized data will be recorded when the image is
recorded using command buttons on the Captured Image window. If the checkbox is not
checked, Auto Data Display text is not memorized even if it is shown on the image.
Fig. 3.6-12 Settings Window Recording Tab
NOTICE:
If this check is turned off, the
data will not be embedded in
the recorded image even
w
hen Auto Data is indicated
on the image.