Filter
Top Products
5 - 15
5. OPERATIONAL FUNCTIONS
5.3.4 Other axes start specification
Set other axes start data number (1 to 32). When the other axes start data number is set, the position board
starts the other axes according to other axes start conditions and operation details of their start data. Up to 2
other axes start data number can be set. For details of other axes start function, refer to Section 6.23.
POINT
If the setting of the other axes start specification is incorrect, it causes a point
table setting error (operation alarm 25, detail 09) and operation is stopped.
5.3.5 S-curve ratio
Perform S-curve acceleration/deceleration for acceleration/deceleration selected in speed options (parameter
No.0220). For automatic operation, this setting is valid regardless of the setting of S-curve ratio (parameter
No.0221).
0: S-curve acceleration/deceleration invalid
1 to 100: S-curve acceleration/deceleration