Filter
Top Products
App. - 40
APPENDIX
(4) When selecting dual port memory
When 4 (dual port memory input) is selected as the sensor destination,
side limit switch input signal
(LSPC),
side limit switch input signal (LSNC) and proximity dog input signal (DOGC) are imported as
substitutes for sensors.
Axis command bits
Address Bit Abbreviation Signal Name
When tandem drive is
being used
1004 0 ITL Interlock Master
1 RMONR High speed monitor latch
command
Each axis
2
Reserved
3
4 LSPC side limit switch input Each axis
5 LSNC side limit switch input Each axis
6 DOGC Proximity dog input Each axis
7 Reserved
Note1: The above address is the address for the axis 1. For the axis 2 and above, add C0h
for each axis.
POINT
When the sensor input command (LSPC, LSNC, DOGC) is turned on, a
normally-open contact turns on (a normally-closed contact turns off). The
polarity of the limit switch input command is the normally closed contact. The
polarity of the proximity dog input command can be changed by proximity dog
input polarity (parameter No.0240).