Filter
Top Products
6 - 91
6. APPLICATION FUNCTIONS
(2) Point table and auxiliary command
To use the pass position interrupt, set the pass position interrupt valid to the auxiliary command of the point
table.
Reserved (bit9 to bit15)
00000
b15
b12
b8 b4 b0
00
Position command system (bit0 to 1)
Reserved (bit2 to 3)
Deceleration check system (bit4 to 5)
Speed switching point specification (bit6)
Dwell specification (bit7)
Pass position interrupt specification (bit8)
00
(a) Pass position interrupt specification
Select valid/invalid for the pass position interrupt.
0: Pass position interrupt invalid
1: Pass position interrupt valid
POINT
This setting in the point data of the start point number is valid only. If the point
data after the start number are set, it causes a point table setting error
(operation alarm 25, detail 0C) and the operation is stopped.
API LIBRARY
Use the sscSetPointDataEx/sscCheckPointDataEx functions to set/get point
data.