Filter
Top Products
5 - 11
5. OPERATIONAL FUNCTIONS
(3) Speed switching point specification
If "2: Continue operation" is selected in the deceleration check system, a point where speed change is
completed can be specified.
0: After point switching
1: Before point switching
(a) After point switching
Command speed 2
Command speed 1
n
n + 1
Operation point
number
(b) Before point switching
Command speed 2
Command speed 1
n
n + 1
Operation point
number
POINT
If "1: Before point switching" is specified, the point table (feed speed) of the
next point is imported (read) at start operation or timing when the point
switches next point. If the setting of the point table of the next point is
incorrect, it causes a point table setting error (operation alarm 25, detail 01)
and operation is stopped.