Filter
Top Products
11 - 4
11. PARAMETERS
11.2 Servo parameters
11.2.1 Servo amplifier MR-J4(W
)- B
The parameters described in this section are for using the servo amplifier MR-J4(W
)- B. For details, refer to
the Servo Amplifier Instruction Manual on your servo amplifier.
POINT
• The parameters with a * mark in front of the parameter abbreviation become
valid according to the following conditions.
*: The setting value for the system startup or the SSCNET reconnection is
valid. The parameter change after the system startup is invalid.
**: The setting value for the system startup or the SSCNET reconnection is
valid. However, after the system startup, turn off the power supply of the
servo amplifier once, and it is necessary to turn on it again. The parameter
change after the system startup is invalid.